Empfängermontage; Table Of Contents Part 1 Welcome To The Guide; Intended Use; Receiver Installation - GRAUPNER 13400 Anleitung

Table of contents part 1
Welcome to the guide ......................................................9
Intended use ...................................................................9
Safety and responsibility ................................................10
Basic safety ...................................................................... 10
Propeller ........................................................................... 10
Target group ..................................................................... 10
Technical specifi cations .................................................11
Recommended accessories ..........................................11
Required tools and adhesives ........................................11
Meaning of the symbols .................................................11
Package content ...........................................................12
Table of contents part 2 Installation instruction out of the box
001 Landing gear installation ...........................................2
002 Rudder/elevator installation .......................................3
003 Rudder/elevator installation .......................................3
003 Rudder/elevator installation .......................................4
004 Tail wheel installation .................................................4
005 Rudder/elevator linkage ............................................5
006 Pilot installation .........................................................6
007 Canopy installation ...................................................6
Welcome to the guide
Thank you very much for having chosen the HoTTrigger 1400S.
The informations in these instructions will support you to assembly your HoTTrigger 1400S in a safe and quick way.
Note:
Part 1
In the part 1 of the instructions you can fi nd the safety and general instructions for installation,
commissioning and use, that are important for a safe use, care, maintenance, troubleshooting and
disposal.
Part 2
In the part 2 there are the instructions that describe the assembly and installation operation, from the box
to the ready to fl y model, with detailed illustrations and setting values.
You can fi nd the last version on the related product page on the web site www.graupner.de.
We wish you fun and joy in assembling and fl ing your HoTTrigger 1400 S

Intended use

This RC model was conceived for the purpose of the fl ight model and is only suitable for this purpose (aerobatics and
3D fl ight shows). The model is suitable for outdoor use in low and middle wind conditions. Every other use is considered
improper. Intended use includes the observance of all instructions in the manual. The manual consists of 2 parts, both
must be kept well and in case the model is sold, they must be passed on the subsequent owner of the model.
Speed controller ............................................................13
Controller technical specifi cations ..................................... 13
Commissioning of the controller ........................................ 13
Programming the controller through the gas stick ............. 13
Disabling the brake ........................................................... 13
Activate the brake ............................................................. 13
Switching on the controller ................................................ 14
Controller protection functions .......................................... 14
Tips and suggestions for the fi rst fl ight ...........................14
Environmental informations ............................................14
Declaration of Conformity ..............................................15
Service and warranty .....................................................15
Service centers ................................................................. 15
Warranty ........................................................................... 15
008 Wings installation ......................................................7
009 Wings lock................................................................8
010 Receiver installation ..................................................9
011 Propeller and Spinner installation ............................10
012 Battery installation ..................................................11
013 Centre of gravity .....................................................11
014 Rudder defl ections F3A ..........................................12
015 Rudder defl ections 3 D ...........................................12
2015/02/12
INNOVATION & TECHNOLOGY
EN
9