AsViva T16 Benutzerhandbuch Seite 25

TROUBLESHOOTING
Electric running simple faults and troubleshooting methods:
1. If the electronic watch displays „E01" after running, it means that the communication fails. The
possible reason is that the communication between the electronic control and the electronic watch is
blocked. Check the electronic watch to the lower control.
At each connection of the cable, ensure that each core is completely inserted. Check whether the
connecting wire between the electronic watch and the controller is damaged, and replace the connec-
ting wire. Check whether the communication line of the electronic watch or controller is damaged, if
damaged, replace the electronic watch or controller.
2. If the electronic meter displays „E02" after running, it is anti-explosion protection, check whether the
power supply voltage is lower than 50% of the normal voltage, please re-test with the correct voltage
specification; check whether the controller has peculiar smell, replace the controller; check the motor
Whether the wire is connected well, reconnect the motor wire.
3. If the electronic watch displays „E03" after running, there is no sensor signal, the possible reason:
the speed sensor signal is not detected for 10 consecutive seconds, check whether the sensor plug is
not plugged in or the magnetic sensor is broken or damaged, and plug it well Or replace the magnetic
sensor.
4. If the electronic meter displays „E05" after running, it is overcurrent protection. The possible reason
is that the current exceeds the rated load and the current is too large, the system is self-protected, or
a certain part of the treadmill is stuck, causing the motor to not rotate and the load If it is too heavy, the
current is too large, and the system is self-protected; adjust the treadmill and restart it. There is also
to check whether there is overcurrent sound or burning smell when the motor is running, replace the
motor; or check whether the controller smells burnt, replace the controller; or check whether the power
supply voltage specification is inconsistent or low, use the correct one Voltage specification retested.
5. E06: Controller self-checking error
6. E07/E08: Replace the controller.
7. If the motor does not run after pressing the start button, the related circuit of the control motor is
abnormal, the lower control fuse is damaged or falls off, or the motor cable is not plugged in properly,
or the IGBT on the lower control is burnt out, check whether the circuit controlling the motor is Plug it
correctly and well, check whether the fuse on the electric control is in good condition, install or replace
it; check whether the motor wire is loose, and plug the motor wire well. Use a multimeter to measure
whether the IGBT on the lower controller is burned out, and replace the IGBT on the lower controller or
replace the lower controller.
48
TECHNICAL INSTRUCTION
Belt adjustment
Factorywise the belt is correctly set up during manufacturing. Sometimes it is neccessary after few
weeks to adjust the belt after using the treadmill for several weeks.
Adjustment of the belt tension:
If you feel that the belt is sliding while running on it, you have to adjust the belt tension.
A. Turn clockwise in 1/4 steps on both sides as shown in the picture below.
B. Repeat this process until the sliding stops.
C. Please do not tighten the screws to hard, to avoid bearing defects.
Centering the belt:
Whilte running, you can step harder with one foot than with the other.
This can cause a missalignemtn of the belt.
A. Let the treadmill run with 6km/h without standing on it.
B. Look if the belt is running in the center..
a. If it's sliding to the left, please turn the left screw clockwise in 1/4 steps, if it slides to the right,
than screw the right screw anticlockwise.
b. If the belt is still not running in the middle, repeat step a until it runs in the middle.
C. Increase the speed to 16km/h and check if the belt is still running in the middle, otherwise repeat
step A and B.
D. If this process is unsuccessful, increase the belt-tension.
.
49