PeakTech P2695 Bedienungsanleitung Seite 11

* Replace the battery as soon as the battery indicator "BAT" appears. With a low battery, the meter
might produce false reading that can lead to electric shock and personal injury.
* Fetch out the battery when the meter will not be used for long period.
* Periodically wipe the cabinet with a damp cloth and mid detergent. Do not use abrasives or
solvents.
* The meter is suitable for indoor use only.
* Do not operate the meter before the cabinet has been closed and screwed safely as terminal can
carry voltage.
* Do not store the meter in a place of explosive, inflammable substances.
* Do not modify the equipment in any way.
* Do not place the equipment face-down on any table or work bench to prevent damaging the
controls at the front.
* Opening the equipment and service – and repair work must only be performed by qualified
service personnel
* Measuring instruments don't belong to children hands.
Cleaning the cabinet
Clean only with a damp, soft cloth and a commercially available mild household cleanser. Ensure
that no water gets inside the equipment to prevent possible shorts and damage to the equipment.
CAUTION!
Note on using the supplied safety test leads according the IEC / EN 61010-031:2008:
Measurements in the field of overvoltage category CAT I or CAT II can be performed with test leads
without sleeves with a maximum of up to 18 mm long, touchable metallic probe, whereas for
measurements in the field of overvoltage category CAT III or CAT IV test leads with put on sleeves,
printed with CAT III and CAT IV must be used, and therefore the touchable and conductive part of
the probes have only max. 4 mm of length.
2. General Specifications
* Large LCD with dual display
* Resistance measurement possible from 0 Ohm up to 4000 MOhm
* Voltage measurement from 0 Volts AC/DC to 1000 V/DC or 750V/AC
* Insulation measurement with 125 Volts up to 1000 Volts
* Over range indicator and low battery indication
* Overload protection in all ranges
* Sturdy and lightweight case
-10-