Swiss Pro+ SP-DISHM Bedienungsanleitung Seite 9

5. Drain pipe connection:
- Connect the drain pipe to the outlet and clamp. The end pipe must not be submerged in water.
- Connect the water supply line and the drain line to the dishwasher. See the picture below:
6. Secure the drain pipe to the sink with the suction cup. See the image below:
Electrical Connection
After checking that the voltage and frequency values for the current in the house correspond to
those on the rating plate and that the electrical system is rated for the maximum voltage specified
on the rating plate, plug the power cord into a properly grounded outlet. The grounding of the device
is a legal safety requirement. If the outlet to which the appliance is to be plugged in is not suitable
for the plug, replace the entire cord rather than using just the adapters or something else as it may
cause overheating and burns.
Add water mode
Manually add water:

- Open the lid of the water tank and then add 4.5 litres of water.
- Before starting up, fill the appliance with water. The appliance will make a beeping sound.
- If the water tank has run out of water after starting up, the "
water is refilled. The appliance will beep when it is refilled and the "
Automatically add water:

- Connect the water pipe to the dishwasher. It will automatically add water.
- Please use the water pressure between 0.03 MPa and 1.0 MPa. If it exceeds 1.0 MPa, the
device will be damaged. If it is less than 0.03 MPa, it will affect the operation of the appliance.
9
" icon will stay on until the
" icon will turn off.