Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Heat-up Indicator
The display shows the temperature in
the oven.
Fast Heat Up Indicator
The function is on. It decreases the heat
up time.
5. BEFORE FIRST USE
WARNING!
Refer to Safety chapters.
5.1 First connection
Before the first use you have to set:
• Set Language
• Display Contrast
• Display Brightness
• Set Time of Day
1. Press
or
2. Press
to confirm.
5.2 Initial preheating and cleaning
Preheat the empty appliance before the first
use and contact with food. The appliance can
emit unpleasant smell and smoke. Ventilate
the room during preheating.
1. Remove all accessories and removable
shelf supports from the appliance.
2. Set the function
temperature. Let the appliance operate
for 1 h.
3. Set the function
temperature. Let the appliance operate
for 15 min.
4. Turn off the appliance and wait until it is
cold.
5. Clean the appliance and the accessories
only with a microfibre cloth, warm water
and a mild detergent.
6. Put the accessories and removable shelf
supports back to their initial position.
5.3 Setting: Water hardness
When you connect the appliance to the mains
you have to set the water hardness level.
to set the value.
. Set the maximum
. Set the maximum
Weight Automatic
The display shows that the automatic
weight system is on or that weight can
be changed.
Heat + Hold
The function is on.
Use the test paper or contact your water
supplier to check the water hardness level.
1. Put the test paper into the tap water for
about 1 sec. Do not put the test paper
under running water.
2. Shake the test paper to remove any
remaining water.
3. After 1 min, check water hardness with
the table below.
4. Set the water hardness level in the menu:
Basic settings.
The colours of the test paper continue to
change. Check the water hardness within 1
min after testing.
You can change the water hardness level in
the menu: Basic settings / Water hardness.
The table shows water hardness range (dH)
with the corresponding level of Calcium
deposit and the water classification. Adjust
the water hardness level according to the
table.
When the tap water hardness level is 4 or
above, fill the water drawer with still bottled
water. Use bottled water with a maximum
2+
calcium deposit Ca
mg/l (check bottle label). If you use the water
softening system make sure that the water
hardness level is between level 1 and 3,
otherwise use bottled water within this range.
For more information about your tap water
hardness (dH) contact your local water
supplier.
of 3.9 mmol/l or 151
ENGLISH
9
Werbung
