Electrolux EB7GL5QSP Benutzerinformation Seite 26

13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem
You cannot activate or operate the
oven.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
The food sensor does not operate.
The display shows F111.
The display shows an error code
that is not in this table.
Steam and condensation settle on
the food and in the cavity of the
oven.
The appliance is activated and does
not heat up. The fan does not oper‐
ate. The display shows "Demo".
The descaling procedure is interrup‐
ted before it finishes.
The descaling procedure is interrup‐
ted before it finishes.
26 ENGLISH
Possible cause
The oven is not connected to an
electrical supply or it is connected
incorrectly.
The oven is turned off.
The clock is not set.
The necessary settings are not set.
The automatic switch-off is on.
The Child Lock is on.
The fuse is blown.
The lamp is defective.
The plug of the food sensor is not
correctly installed into the socket.
The plug of the food sensor is not
correctly installed into the socket.
There is an electrical fault.
You left the dish in the oven for too
long.
The demo mode is activated.
There was a power cut.
The function was stopped by the
user.
Remedy
Check if the oven is correctly con‐
nected to the electrical supply (refer
to the connection diagram if availa‐
ble).
Turn on the oven.
Set the clock.
Make sure that the settings are cor‐
rect.
Refer to "Automatic switch-off".
Refer to "Using the Child Lock".
Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
Replace the lamp.
Put the plug of the food sensor as
far as possible into the socket.
Put the plug of the food sensor as
far as possible into the socket.
• Turn off the oven with the house
fuse or the safety switch in the
fuse box and turn it on again.
• If the display shows the error
code again, contact the Custom‐
er Care Department.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
Refer to "Daily Use chapter, Basic
Settings.
Repeat the procedure.
Repeat the procedure.