Werbung
Verfügbare Sprachen
Verfügbare Sprachen
belts (fig. 12).
Note! Make sure the seat belts are tight, fit snugly around the child's body and
are not twisted. Make sure the lap belts run low and protect the child's pelvis.
The belts should be tight against the child's body, but should not be too tight and
cause discomfort.Note! Children under 60 cm in height may only use the seat
with a reduction insert.
HEADREST ADJUSTMENT
To change the height of the headrest:
1.
Unbuckle and loosen the seat belts by holding down the seat belt tension
adjustment button (6, fig. B). This will allow you to adjust the height of the
headrest more freely.
2.
Pull the headrest adjustment lever (fig. 15).
The shoulder belt height setting is integrated into the headrest height setting. By
adjusting the height of the headrest, the height of the shoulder belts will be set
automatically.
Note! The headrest should be adjusted so that the shoulder belts are not too high,
such as at or above the ear line, nor too low, such as behind the child's back. The
shoulder belts should be at child's shoulder height (fig. 16).
5-POINT SEAT BELT RETRACTION
NOTE! The following information is valid for the 100 - 150 cm group.
1.
Unbuckle the seat belts by pressing the central red button on the buckle
(fig. 13).
2.
Remove the reduction insert (fig. 17) and remove the seat belt buckle cover
(fig. 18).
Unfasten the metal clasps on the upper backrest pad and lift the pad upwards.
3.
4.
Pass the seat belt buckle through the corresponding hole in the seat cover
(fig. 19) and release the crotch belt by passing the metal buckle through
the hole in the seat.
5.
Unfasten the metal clasps at the bottom of the seat cover.
6.
Connect the belt connectors and then insert them into the buckle. You will
hear a characteristic click (fig. 20).
EN
‑ 18 ‑
Werbung
