Lionelo Bastiaan ONE i-Size Bedienungsanleitung Seite 17

it will not allow to change position.
3. Place the seat on the vehicle's couch in the position designated for installation.
4. Adjust the recline of the seat in the sitting position (see: Seat tilt adjustment).
Note! For installation without ISOFIX system, skip steps 5 to 8.
5. Push the ISOFIX sliding lever and extend the ISOFIX arms (fig. 1). Attach the
ISOFIX arms to the attachments located in the vehicle's couch. The arms will
interlock and you will hear a characteristic click.
6. The green indicator on the ISOFIX button must be visible on both sides (fig. 2).
7. If necessary, use the plastic guides provided to make installation easier (fig. 3).
8. Push the seat against the backrest of the vehicle's couch. Push the base
with left-right movements towards the backrest to make sure it is pressed
as tightly as possible against the vehicle's couch.
9. Place the child in the seat and adjust the headrest (see: Headrest adjustment).
10. Remove the car seat belt.
11. Guide the shoulder belt through the shoulder belt guide, which is located
at the bottom of the seat headrest (A, fig. 11). Pass the lap belt through the
lap belt guide (B, fig. 11).
12. Fasten the seat belt (C, fig. 11). You will hear a characteristic click.
13. Make sure the belts are not twisted.
14. Make sure the belts are correctly positioned in the guides and tightened,
and that the buckle is not too close to the lap belt guide.
FASTENING AND UNFASTENING THE SEAT BELTS
1. Loosen the seat belts by pressing the tension adjustment button (6, fig. B)
and pulling the belts (fig. 12).
2. Unbuckle the belts by pressing the red button on the buckle (fig. 13).
3. Put the child in the seat.
4. Adjust the headrest (see: Headrest adjustment).
5. Connect the belt connectors and then insert them into the buckle (fig. 14).
You will hear a characteristic click and a green indicator will appear next to
the buckle button (fig. 14a). The seat belts are now fastened.
6. To tighten the belts, pull the belt tension adjustment strap (5, fig. B). To
loosen the belts, press the belt adjustment button and pull on the shoulder
‑ 17 ‑ EN