Siebert S102 Serie Bedienungsanleitung Seite 15

Features
Brillant LED display
Two potential-free switching outputs
User defined scaling
No-voltage protected
Parameterization via menu
Plug-in screw terminal strip
Control
The units must be parameterized before they can be controlled. Parameterization
occurs in a menu (see 'Parameterization').
In the following, the numbers in [ ] refer to the corresponding line in the function table.
Counting functions
The signal inputs D2 and D1 are counting inputs. The following counting functions
are possible:
Signal inputs
Setting 1 in menu item 1
Setting 2 in menu item 1
Setting 3 in menu item 1
Setting 4 in menu item 1
If setting 1 is selected in menu item 1, the pulses arriving at input D1 will be counted.
With an L signal at input D2 pulses will be counted upward. With an H signal at input
D2 they will be counted downward [1].
If in menu item 1 setting 2 is selected, the pulses arriving at inputs D1 and D2 will be
counted upward independently one from the other [2].
If in menu item 1 setting 3 is selected, the pulses arriving at inputs D1 and D2 will be
counted downward independently one from the other [3].
If in menu item 1 setting 4 is selected, the pulses arriving at inputs D1 and D2 will be
counted downward independently one from the other [4].
BAL S102 ZLR M 0.1
D2
[1] L = upward, H = downward
[2] Counting upward
[3] Counting downward
[4] Counting downward
D1
Counting pulse
Counting upward
Counting upward
Counting downward
15