hanseatic HFD20070CWDI Gebrauchsanleitung Seite 52

In such cases, remove the mains plug
from the socket or unscrew/isolate
the fuse and contact our Service de-
partment (see pagepage EN-33).
■ Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
■ Since all poles of the appliance can-
not be disconnected from the mains
via an accessible disconnecting de-
vice, an all-pole disconnecting device
in accordance with overvoltage cate-
gory III must be connected within the
house installation with at least 3 mm
contact clearance; consult a qualifi ed
professional if necessary (see „Ser-
vice" on page EN-33).
■ When positioning the appliance, en-
sure the supply cord is not trapped or
damaged. Do not kink or pinch the
mains cable or lay it over sharp edg-
es. This can result in a break in the ca-
ble.
CAUTION
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■ Connect the appliance only to a
properly installed and earthed elec-
tric socket. Do not connect to a mul-
ti-socket extension cable or a mul-
ti-socket plug.
■ Do not locate multiple portable sock-
et-outlets or portable power supplies
at the rear of the appliance.
Start-up
NOTICE
Risk of damage to property!
If the cooling appliance has been trans-
ported horizontally, lubricant from the
compressor may get into the cooling
circuit.
■ If possible, do not tilt the cooling ap-
pliance horizontally.
■ Allow the appliance to stand upright
for approx. 2 hours after transport
and before connecting. This allows
the lubricant enough time to fl ow
back into the compressor.
• Insert the mains plug into an easily acces-
sible and properly installed socket (220–
240 V~ / 50 Hz).
You will find all important information
about operation from pagepage EN-18.
Page EN-15