hanseatic HFD20070CWDI Gebrauchsanleitung Seite 43

Page EN-6 Safety
■ Inspections and repairs to the ap-
pliance may only be carried out by
authorised specialists. Please contact
our service department if necessary
(see „Service" on page EN-33).
■ This appliance contains electrical and
mechanical parts which are essential
for protection against potential sourc-
es of danger. Only parts correspond-
ing to the original appliance specifi -
cations may be used for repairs.
■ In the event of a fault, as well as be-
fore extensive cleaning, pull out the
mains plug or isolate/unscrew the
fuse.
■ Do not put any objects in or through
the housing openings, and also en-
sure that children cannot insert any
objects into them.
■ Do not remove the covers from the in-
terior light. Do not attempt to replace
the interior light. Please contact our
service department if necessary (see
„Service" on page EN-33).
■ Check the appliance regularly for
damage.
Fire hazard!
Improper handling of the appliance can
lead to fi re and damage to property.
■ Do not connect to a timer or a sepa-
rate remote-controlled system for dis-
tance monitoring and control.
Risks associated with using
refrigerants
WARNING
Risk of fi re and explosion!
Your appliance's refrigeration circuit
contains the environmentally friendly,
but fl ammable and – as a mixture of air
and gas – explosive refrigerant R600a
(isobutane).
■ Do not use mechanical devices or oth-
er means to accelerate the defrost-
ing process, other than those recom-
mended by the manufacturer.
■ Mechanical intervention in the refrig-
eration system must only be carried
out by authorised specialists.
■ Do not damage the refrigerant cir-
cuit, e.g. by puncturing the refrigerant
channels of the condensate evapora-
tor with sharp objects, bending the
piping, or cutting open the insulation.
■ Ensure that none of the cooling fi ns
or tubes on a cooling appliance are
damaged prior to the point of proper
disposal.
■ To prevent the formation of a fl am-
mable gas-air mixture in the event of
a leakage in the refrigeration circuit,
the installation space must have a
minimum size of 1 m
frigerant in compliance with the EN
378 standard. The amount of refrig-
erant contained in your appliance
can be found on the type plate.
■ To avoid the formation of sparks, do
not pull out the mains plug in the
event of a gas leak.
■ Dispose of old electrical appliances
at an authorised collection or return
point.
■ Only use original accessories.
per 8 g of re-
3