Werbung
Verfügbare Sprachen
Verfügbare Sprachen
g) Use electric tools, insertion tools, etc. according
to these instructions. Take into account the work-
ing conditions and the work to be performed. Use
of the power tool for operations different from those in-
tended could result in a hazardous situation.
h) Keep handles and grasping surfaces dry, clean
and free from oil and grease. Slippery handles and
grasping surfaces do not allow for safe handling and
control of the tool in unexpected situations.
5) Service
a) Only have your power tool repaired by qualified
specialists and only with original spare parts. This
will ensure that the safety of the power tool is main-
tained.
5.1
Safety instructions for
lawnmowers
• Never allow children or other persons who are unfa-
miliar with the usage instructions to use the lawnmow-
er. Contact your local governmental agency for infor-
mation regarding minimum age requirements for oper-
ating the lawnmower.
• Never mow while people, especially children or ani-
mals are nearby. Always keep in mind that the opera-
tor is responsible for accidents involving other persons
and/or their property.
• Only mow when visibility is good. It is necessary to
keep third parties away.
• If you give the device to any other person, give them
this operating manual as well.
• Always wear sturdy, non-slip footwear and long trou-
sers when mowing. Never mow barefoot or in sandals.
• Check the terrain on which the machine will be used
and remove all objects that could be caught up and vi-
olently flung out of the chute (like stones, toys, sticks
and wires etc.).
• Switch off the motor, wait for it to stop, remove the
battery and pull out the safety key if
– You are leaving the device.
– You are removing blockages or obstructions.
– The product has been in contact with foreign ob-
jects.
– Malfunctions and unusual vibrations occur on the
device.
ATTENTION
Danger of flying stones!
Never drive over gravel with the motor running.
• Prior to use. always perform a visual inspection to
check whether the blade and fastening bolts are worn
out or damaged. To prevent an imbalance, worn out
or damaged blades and bolts may only be replaced in
sets.
5.2
Handling
• Make sure that all nuts, bolts and screws are securely
tightened so that the product is kept in a safe working
condition.
• Regularly check the catch basket for signs of wear
and loss of functionality.
• For safety reasons, replace worn or damaged parts.
• Only mow in daylight or with good artificial lighting.
• Avoid using the product on wet grass as far as possi-
ble.
• Do not use the product in a thunderstorm - Danger of
lightning strike!
• Always maintain good footing on inclines.
• Only guide the product at walking pace.
• Operating the product at excessive speed can in-
crease the risk of accidents.
• The following applies to wheeled products: Always
mow across hills i.e. never straight up or straight
down. Take particular care when changing direction
on a slope.
• Do not mow on excessively steep slopes and nearby
rubbish tips, ditches and dykes. Take particular care
when reversing the product or pulling it towards you.
• Stop the blade when the lawnmower has to be tilted,
when transporting over areas other than grass and
when moving the lawnmower to and from the area to
be mowed.
CAUTION
The lawnmower must not be used without either the full
grass catcher or the self-closing separating guard for
the ejection opening in place.
• Never use the lawnmower if the blade or safety grilles
are damaged, or without the attached guards, e.g. de-
flectors and/or grass catching devices.
• Start the engine with care, in accordance with the
manufacturers instructions. Ensure that your feet are
far enough away from the blade.
• Do not tip the lawnmower when you start the engine
unless the lawnmower must be raised off of the
ground a little in order to start it. In this case, only tilt
as far as absolutely required and only lift the side
away from the operator.
• Do not start the engine if you are standing in front of
the ejector chute.
• Never out hands and feet on or under rotating parts.
Always keep clear of the ejection opening.
• Never lift or carry a lawnmower while the engine is
running.
• Stop the motor and make sure that all moving parts
have come to a standstill and that the battery, if pres-
ent, is removed:
– Before you dislodge any blockages or clogs in the
ejector chute.
– Before checking or cleaning the product, or per-
forming work on it.
– If it came into contact with a foreign object. Inspect
the product for damage and perform the required
repairs before starting again and working with the
product. If the product begins to experience ex-
ceptionally strong vibrations, switch it off immedi-
ately and check it.
– Any time you leave the product.
www.scheppach.com
GB | 23
Werbung
