Husqvarna Aspire S20-P4A Bedienungsanweisung Seite 10

(Fig. 11)
Risk of injury. Keep hands away from
cutting tool.
(Fig. 12)
The product complies with the applicable
EU directives.
(Fig. 13) This product conforms to the applicable
UK regulations.
(Fig. 14) Noise emission to the environment
label as per EU and UK directives
(Fig. 18)
(Fig. 19)
Note:
Other symbols/decals on the product refer to
special certification requirements for certain markets.
Symbols on the battery and/or on the
battery charger
(Fig. 20)
(Fig. 21)
(Fig. 22) Protect the battery against heat, e.g.
against continuous intense sunlight, fire,
(Fig. 23)
dirt, water and moisture. There is a risk
of explosion and short-circuiting.
Safety definitions
Warnings, cautions and notes are used to point out
specially important parts of the manual.
WARNING:
injury or death for the operator or bystanders
if the instructions in the manual are not
obeyed.
CAUTION:
Used if there is a risk of
damage to the product, other materials or
10
DANGER - Keep sufficient distance away from electrical power lines.
The rating plate or the laser printing shows the serial number. yyyy is the produc-
tion year and ww is the production week.
Recycle this product
at a recycling sta-
tion for electrical and
electronic equipment.
(Applies to Europe
only)
Use the battery on-
ly in products from
POWER FOR ALL
System partners.
Safety
Used if there is a risk of
and regulations, and New South Wales
legislation "Protection of the Environment
Operations (Noise Control) Regulation
2017". The guaranteed sound power level
of the product is specified in
data on page 22 and on the label.
(Fig. 15)
The product or package of the product
is not domestic waste. Recycle it at
a recycling station for electrical and
electronic equipment.
(Fig. 16)
Use and keep the battery charger indoors
only.
(Fig. 17) Double insulation.
Product damage
We are not responsible for damages to our product if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not
from the manufacturer or not approved by the
manufacturer.
• the product has an accessory that is not from the
manufacturer or not approved by the manufacturer.
• the product is not repaired at an approved service
center or by an approved authority.
Manufacturer
Husqvarna AB
Drottninggatan 2, SE-561 82 Huskvarna, Sweden, tel:
+46-36-146 500
the adjacent area if the instructions in the
manual are not obeyed.
Note:
Used to give more information that is necessary
in a given situation.
General power tool safety warnings
WARNING:
instructions, illustrations and specifications
provided with this power tool. Failure to
follow the warnings and instructions may
Technical
Read all safety warnings,
2200 - 004 - 03.11.2023