Werbung
Verfügbare Sprachen
Verfügbare Sprachen
To add the Parameter or Function to the Welding
Parameters Bar [44]:
Access to the User Setup (see the Figure 13).
Use the Right Knob [36] to highlight the parameter or
function icon which will be added to the Welding
Parameters Bar [44], for example Run-in WFS.
Figure 14.
Press the Right Knob [36] to confirm the selection.
Run-in WFS icon will drop.
Figure 15.
WARNING
To remove the icon - press the Right Knob [36] once
again.
To exit the User Setup Menu – press the Left Button
[35].
The Selected parameters or function is added to the
Welding Parameters Bar [44].
Figure 16.
English
To remove the selected parameter or function from the
Welding Parameters Bar [44]:
Access to the User Setup.
Use the Right Knob [36] to highlight the parameter or
function icon which is added to the Welding
Parameters Bar [44].
Press the Right Knob [36] – The selected icon will
disappear from the display bottom.
The
Selected
disappeared from the Welding Parameters Bar [44]
19
Figure 17.
Figure 18.
parameters
or
function
Figure 19.
English
was
Werbung
