Lincoln Electric OERLIKON CITOSTEEL 255C Bedienungsanleitung Seite 15

Table 1.
LED Light
Only machines which using
Condition
Steady Green System
operational, and is communicating
normally with all healthy peripheral
equipment.
Blinking Green Occurs during power up or a system
reset, and indicates the power
source is mapping (identifying)
each component in the system.
Normal for first 1-10 seconds after
power is turned on, or if the system
configuration
operation.
Alternating If the status lights are flashing any
Green and Red combination of red and green, errors
are present in the power source.
Individual code digits are flashed in
red with a long pause between
digits. If more than one code is
present, the codes will be separated
by green light. Read the error code
before the machine is turned off.
If occurs, to clear the error try to turn
Off the machine, wait for a few
seconds, then turn ON again. If the
error remains, a maintenance is
required. Please contact the nearest
authorized technical service center
or Lincoln Electric and report the
error code read.
Steady Red Indicate no communication between
the power source and device which
has been connected to this power
source.
29. LED Indicator: Informs that the wire feed speed is on
the Left display.
30. LED Indicator: Informs that the value on the Left
display is in ampere units.
31. LED Indicator: Informs that the value on the Right
display is in volts unit.
32. Welding Programs Indicators: lamps indicate the
active weld mode. Descriptions of parameters are in
Table 2.
33. Welding parameters Indicators: lamps indicate the
active weld parameters. Descriptions of parameters
are in Table 3.
English
Meaning
®
ArcLink protocol for
communication
OK. Power source
is changed during
Welding Process Change
It is possible to quick recall of one of the six manual
welding programs - Table 2.
Table 2. Manual Weld Modes:
Symbol
is
GMAW
FCAW
SMAW
To set the welding process:

Press the Left Button [26] to select an adequate
welding process- the weld program indicator [32] the
first weld program indicator [32] lights on.

Again, press the Left Button [26] the weld program
indicator will jump to the next mode.
During switching the displays show a "creeping line" on
the screen.
11
LED Process
GMAW MIX
GMAW CO
GMAW AR
FCAW MIX
FCAW CO
SMAW
WARNING
2
2
English