Werbung
Verfügbare Sprachen
Verfügbare Sprachen
If a user does not know the Welding Program Number, it can be
searched. In that case in subsequent steps are given:
The
Welding
Process
The Electrode
Wire Type
The Electrode
Wire
Diameter
The Shielding
Gas
Support
To access the Support Menu:
Press the Button [37] or Right Knob [36] to get
access of Welding Parameters Bar.
Use the Right Knob [36] to highlight the icon
"Support".
Press the Right Knob [36] to confirm the selection.
The Support Menu enables to get knowledge of the
following points:
Accessories:
-
Rolls for aluminum wire
-
Rolls for fluxed cored wire
-
Rolls for steel/stainless steel wire
-
TIG torches
-
Electrode & Ground cable
-
MIG/MAG LINC GUN Standard
Tips and Tricks:
-
Tutorial
-
Welding variables effect MIG
English
User Setup
To access the User Setup:
Press the Button [37] or Right Knob [36] to get
access of Welding Parameters Bar.
Use the Right Knob [36] to highlight the icon
"Settings".
Press the Right Knob [36] to confirm the selection.
The User Setting Menu enables to add the additional
function and / or parameters to the Welding Parameters
Bar [44]:
Table 9.
Symbol
Description
Preflow
Postflow
Burnback Time
Spot Welding
Run-In WFS
Start Procedure
Crater Procedure
A/B Procedure
Load memory
Save memory
USB Memory
To change the Parameters or Functions Value, theirs
icons had to be added to the Welding Parameters Bar
[44].
18
Figure 13.
WARNING
English
Werbung
