Werbung
Verfügbare Sprachen
Verfügbare Sprachen
2
Operation
2.7.2 Operating the locomotive
with DELTA
To operate the locomotive with Märklin
DELTA you use the DELTA-Mobil to
select the address that has been set
on the former. The locomotive will
run forward when you turn the speed
control knob to the right of the center
position. Turning the speed control
knob to the left of the center position
will cause the locomotive to run in
reverse. The headlights change
direction with the direction of travel
and are on all of the time. The maxi-
mum power output of the DELTA-
Station is sufficient to operate 2 to a
maximum of 3 single motor locomoti-
ves at the same time.
The smoke generator is on constant-
ly when the locomotive is operated
with the DELTA Station. The other
28
functions are turned off. The smoke
generator must not be operated
without smoke fluid in it. For that
reason you should remove the
smoke generator if you want to run
the model for long periods of time
without smoke fluid.
The digital address of 78 set in the
locomotive and the cars is the same
as the DELTA address 1. This loco-
motive can therefore be run with the
DELTA Station. The lighting in the
cars will be turned on as long as the
decoder address set in the cars is
the same as the decoder address for
the locomotive.
2.7.3 Operating the locomotive
on alternating current
When the locomotive is operated with
AC power in conventional operation,
the 32 VA transformer (no. 6645,
6646, 6647 or 76648) can be used.
Locomotive speed is increased by
turning the control knob to the right
and is decreased by turning the knob
to the left. The direction of travel is
changed by turning the control knob
to the left past the "0" setting.
The command to reverse should be
given only to a standing locomotive,
never to one in motion. In operation
with alternating current the headlights
change direction with the direction of
travel and are on all of the time. The
intensity of the headlights depends
on the speed of the locomotive.
The smoke generator in the locomo-
tive is on continuously when the
locomotive is operated with conven-
tional AC power. The other functions
are turned off. The smoke generator
must not be operated without smoke
fluid in it. For that reason you should
remove the smoke generator if you
want to run the model for long peri-
ods of time without smoke fluid.
The lighting in the cars works only
if all 8 of the coding switches on the
lighting decoder are set for "off". In
this situation the car lighting works
only when the train is being run at
high speeds.
Werbung
