Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TEX 05PE, 09PE, 12PE
A
TEX 05PE
1. Place the cap over the hexagon body of the
insertion tool.
2. Place the buffer (A) over the stem of the insertion
tool.
3. Insert the insertion tool into the cylinder and
screw the cap onto the cylinder until it is locked.
A
TEX 09PE, TEX 12PE
1. Fit/remove the insertion tool.
2. Close the tool retainer (position A) and check the
lock function by tugging the inserted tool sharply
outwards.
Operation
WARNING Involuntary start
Involuntary start of the machine may cause injury.
Keep your hands away from the start and stop
►
device until you are ready to start the machine.
►
Learn how the machine is switched off in the event
of an emergency.
Stop the machine immediately in all cases of
►
power supply interruption.
© 2014 Construction Tools PC AB | No. 9800 0812 90f | 2014-08-12
Original instructions
Safety and operating instructions
Start and stop
Start the machine by squeezing the trigger while
firmly holding the handle.
Stop the machine by releasing the trigger. The trigger
returns automatically to the stop position.
Operating
Starting a cut
♦
Stand in a stable position with your feet well away
from the inserted tool.
♦
Press the machine against the working surface
before you start.
♦
Start collaring at such a distance from the edge
that the machine is capable of breaking the
material without levering.
♦
Never try to break off too large pieces. Adjust the
breaking distance (A) so that the inserted tool does
not get stuck.
A
17
Werbung
