Veratron VL FLEX 52MM Serie Bedienungsanleitung Seite 9

MOUNTING WITH SPINLOCK NUT
Conventional mounting. (Device is inserted into the hole from the front).
The panel thickness can be in the range of 0.5 to 20 mm. The hole must have a diameter of 53 mm [B].
• Do not drill holes and installation openings in load-bearing or stabilizing struts or spars!
• For the installation location, ensure the necessary clearance behind the holes or the installation
opening. Required installation depth 65 mm.
• Pre-drill small installation openings, enlarge with cone cutter, hole saw, jigsaw or file if necessary and
finish. Deburr edges. Refer to the safety instructions of the hand tool manufacturer.
1. Different covers can be mounted as an
alternative to the supplied cover. In this case,
carefully remove it with a screwdriver [A],
attach the new bezel to the instrument and
press it until it is flush with the cover glass.
Note: When removing, the front ring
damaged and can no longer be used
be
IMPORTANT: If you install a chrome bezel, you
must set up the device before installation. The
metal particles contained in the chrome trim
may affect the performance of the wireless
interface!
A
C
7
2. Make a round hole, taking into account the
external dimensions of the device. [B]
3. Remove the spinlock nut and insert the device
frontally. [C]
4. Align the spinlock nut as shown in [D],
according to the thickness of the plate.
5. Feed the cables through the spinlock nut and
carefully screw it in at least two turns.
6. Connect the plugs.
B
D
INSTALLATION
B000882