Veratron VL FLEX 52MM Serie Bedienungsanleitung Seite 10

FLUSH MOUNTING
The recommended panel thickness is 1.5 to 3mm. The hole must have a diameter of 48.1mm [A].
Make sure that the installation location is level and has no sharp edges.
• Do not drill holes and installation openings in load-bearing or stabilizing struts or spars!
• For the installation location, ensure the necessary clearance behind the holes or the installation
opening. Required installation depth 65 mm.
• Pre-drill small installation openings, enlarge with cone cutter, hole saw, jigsaw or file if necessary and
finish. Deburr edges. Refer to the safety instructions of the hand tool manufacturer.
1. Make a round hole, considering the external
dimensions of the device. [A]
2. Remove the spinlock nut
3. Remove the front ring using a screwdriver. [B]
Note: When removing, the orifice plate will be
damaged and can no longer be used.
A
C
8
4. Place the flush mount gasket A2C53215640 (not
included) on the cover glass.
5. Insert the device into the hole [C] from behind.
6. Align the unit so that the reading is straight and
fix it to the studs [D] attached to the back of the
panel using the flush mount mounting bracket
A2C59510864 (not included).
7. Connect the plugs.
B
D
INSTALLATION
B000882