Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Dear Client,
Thank you for purchasing our thermodynamic water heater. We want it to be able to meet all
your expectations and provide you with the best services and maximum energy savings for many
years.
This manual is intended for the installer and the end user, who will need to install and use the
thermodynamic water heater respectively. Failure to comply with the instructions in this manual
results in the loss of the product warranty and affects the performance of the device.
Before installing and using this product, please read this manual carefully to avoid damage or
accident caused by improper use.
Information is subject to change without notice.
Safety instructions
1. If the power cord is damaged, it must be replaced by the manufacturer, or a person with similar
qualifications in order to avoid any danger.
2. This device may be used by children from 8 years of age and by persons with reduced
physical, sensory or mental capabilities or who do not have the necessary knowledge or
experience, provided that they are supervised or have been trained appropriately for the safe
use of the device and informed of the dangers associated with it. Children should not play with
the appliance. Cleaning and maintenance operations at the user's expense may under no
circumstances be carried out by children without supervision.
3. In order to avoid any risk of accidental resetting of the circuit breaker, this device must not be
powered by an external switching device, such as a timer, or be connected to a circuit that is
regularly switched on and off by the public service.
4. Installation and maintenance must be carried out by a qualified professional.
5. When the temperature of the house is below 0°C and the device does not work or is not
powered, please drain the water from all pipes.
6. Use clean water to clean the evaporator fins regularly, otherwise the normal operation of the
device will be affected. Turn off the appliance during cleaning.
7. Do not use the device to heat groundwater, seawater or other hard water, otherwise the heat
transfer performance will be affected and the heat exchanger and the compressor assembly will
be damaged.
8. It is mandatory to install a safety group as close as possible to the cold water inlet of the water
heater. This device must comply with the EN 1487:2000 standard, maximum pressure of 0.7
MPa (7 bar) and must have at least: a stop valve, a check valve, a check valve control device, a
safety valve, a network pressure interruption device.
9. Packaging should not be left within the reach of children, as it can be dangerous.
10. The installation and the first commissioning of the device must be carried out by qualified/
professional persons, in accordance with the national installation standards in force and
Werbung
