Kärcher IVR 60/30 Sc M ACD Bedienungsanleitung Seite 25

Replacing the filter
DANGER
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Accumulated dust must be transported in
dust-proof containers. Do not transfer the
contents. The dust bag may only be dis-
posed of by qualified staff.
WARNING
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Do not use the filter element after removing
it from the device.
Permanently installed filters may only be
replaced in suitable areas, e.g.in so-called
decontamination stations) by a technical
expert.
Illustration K
Clamping ring
1
filter
2
Nuts
3
Cleaning fixture
4
1. Remove the suction head, see chapter
Removing the suction head.
2. Remove the filter unit from the device
using the handles and turn it over.
Illustration L
3. Remove the nuts and remove the clean-
ing fixture.
4. Loosen the clamping ring screw connec-
tion.
5. Remove the filter.
6. Dispose of the foam filter.
7. Fit a new filter.
8. Insert the new foam filter.
9. Fit the tensioning ring and screw it in
place.
10.Fit the cleaning device and screw it on.
11.Insert the filter inlay.
In doing so, make sure the tab on the fil-
ter inlay fits into the shaft.
Illustration M
Replacing the dust bag
DANGER
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Accumulated dust must be transported in
dust-proof containers. Do not transfer the
contents. The dust bag may only be dis-
posed of by qualified staff.
1. Secure the device with the parking
brakes.
2. Remove the suction hose if necessary.
3. Disconnect the pressure equalisation
hose from the dirt receptacle.
Illustration D
4. Lower the dirt receptacle by pulling up
the lever.
Illustration E
5. Pull the dirt receptacle out of the device.
Illustration G
6. Turn up the dust bag.
7. Seal the dust bag tightly with the cable
tie.
8. Remove the dust bag.
9. Dispose of the dust bag in accordance
with statutory regulations.
Illustration F
10.Insert the new dust bag in the dirt recep-
tacle and carefully place it against the
container wall and the container floor.
11.Fold the edge of the dust bag over the
edge of the dirt receptacle to the outside.
Illustration E
12.Fit the dirt receptacle in the device.
Illustration D
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the le-
vers with both hands.
13.Lock the dirt receptacle with the levers.
14.Fit the pressure equalisation hose on
the dirt receptacle.
English 25