Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Power Hose diameter Value
3.0 kW DN40
3.0 kW DN50
4.0 kW DN40
4.0 kW DN50
Clean the filter before or when the spec-
ified value is reached.
Cleaning the filter
Note
Clean the filter regularly to avoid declining
suction power.
Illustration I
1. Move the filter cleaning handle back and
forth several times to clean the filter.
Switching off the device
1. Switch off the device at the On/Off
switch.
2. Empty and clean the dirt receptacle.
3. Remove the accessory and clean and
dry if necessary.
Each time after use
Emptying the dirt receptacle
The dirt receptacle must be emptied as
necessary and after each use.
1. Switch off the device and disconnect
from the mains supply.
2. Clean the filter.
3. Remove the dirt receptacle from the de-
vice and replace the dust bag (see chap-
ter Replacing the dust bag).
Note
Only move the dirt receptacle on its rollers.
Do not use a crane, forklift or similar
means.
Removing the suction head
CAUTION
Failure to observe the weight
Risk of injury and damage
Only lift the suction head. Because of its
weight, do not remove the suction head by
hand.
200 mbar (20
kPA)
150 mbar (15
kPA)
226 mbar (22.6
kPA)
216 mbar (21.6
kPA)
English
DANGER
Failure to observe the weight
Risk of injury from falling device
Observe the applicable accident prevention
guidelines and safety instructions.
Every time before lifting, check to ensure
correct functioning of the lifting device.
Only lift the device via the provided crane
grommet.
Ensure that there will be no unintentional
unhooking of the lifted load.
The crane may exclusively be operated by
qualified staff.
No people may be located within the haz-
ard zone of the crane.
Do not leave the device hanging unattend-
ed on the crane.
Illustration J
1. Switch off the device and disconnect it
from the mains supply.
2. Open the suction head lock.
3. Attach a suitable hoist to the crane
grommet.
4. Use the crane to lift the suction head and
place it on a suitable surface.
Storing the device
1. Wind the mains cable onto the cable
holders.
2. Store the device in a dry room and se-
cure it against unauthorised use.
Transport
CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during
transportation.
The dirt receptacle is emptied.
1. Close the suction connection for dust-
free transport (see chapter Closing the
suction connection).
2. Release the parking brakes and push
the device by the push handle.
3. Grasp the device by the chassis and the
push handle for loading.
4. Secure the device against slipping and
tipping over when transporting in vehi-
cles.
23
Werbung
