Kärcher IVR 60/30 Sc M ACD Bedienungsanleitung Seite 22

Illustration F
5. Fit the dust bag in the dirt receptacle and
carefully position it against the container
wall and the container floor.
6. Fold the edge of the dust bag over the
edge of the dirt receptacle to the outside.
Illustration E
7. Fit the dirt receptacle in the device.
Illustration D
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the le-
vers with both hands.
8. Lock the dirt receptacle with the levers.
9. Fit the pressure equalisation hose on the
dirt receptacle.
Removing the dust bag
DANGER
Danger from dust that is harmful to your
health
Respiratory sicknesses through inhalation
of dust.
Accumulated dust must be transported in
dust-proof containers. Do not transfer the
contents. The dust bag may only be dis-
posed of by qualified staff.
1. Secure the device with the parking
brakes.
2. Remove the suction hose if necessary.
3. Disconnect the pressure equalisation
hose from the dirt receptacle.
Illustration D
4. Lower the dirt receptacle by pulling up
the lever.
Illustration E
5. Pull the dirt receptacle out of the device.
Illustration G
6. Turn up the dust bag.
7. Seal the dust bag tightly with the cable
tie.
8. Remove the dust bag.
22
9. Dispose of the dust bag in accordance
with statutory regulations.
Illustration E
10.Fit the dirt receptacle in the device.
Illustration D
WARNING
Improper handling when locking the dirt
receptacle
Risk of crushing
Under no circumstances should you hold
your hands between the dirt receptacle and
filter ring or allow them to come close to the
lifting mechanism while locking it.
Lock the dirt receptacle by operating the le-
vers with both hands.
11.Lock the dirt receptacle with the levers.
12.Fit the pressure equalisation hose on
the dirt receptacle
Switching on the device
1. Plug the mains plug into the socket.
2. Switch on the device at the trigger.
Illustration H
3. Start vacuuming.
Reading the minimum volumetric
A gauge is mounted on the front of the de-
vice that shows the vacuum intensity (see
chapter Device description).
The table shows the maximum vacuum in-
tensity value. This value depends on the
unit performance and the suction hose
used.
ATTENTION
Suction loss
If the specified value is exceeded, the air
speed in the suction hose drops below 20
m/s.
Clean the filter when the value is reached,
or sooner (see chapter Cleaning the filter.
Replace the filter if the value is not signifi-
cantly reduced by cleaning (see chapter
Replacing the filter).
English
flow