General Notes; Technical Data - Wimtec Rohbauset W7 Montageanleitung

EN
Flush-mount set W7

General notes

The "General
installation terms and
conditions" provided at
www.wimtec.com apply.

Technical data

6
This manual is valid for the following products:
WimTec W7 flush-mount set Art.Nr. 129 182
Delivery scope:
Wall-recess unit with 2 shut-off valves, pre-filters and
reflux preventer, mixer, 1 magnetic valve and cover plate.
Important installation notes:
!
Provide for a flush-mount box for an optional power supply out-
side of the protected zone. Mounting and installation may only be
performed by a qualified service provider in accordance with DIN
1988, ÖVE/ÖNORM E8001 and VDE 0100 Part 701. When planning and
installing sanitary facilities, all relevant local, national and inter-
national standards and provisions must be observed!
Operating voltage:
Power consumption: max. 3.5 W
Flow pressure:
Static pressure:
Flow rate:
Water temperature: max. 70 °C (max. 80 °C for max. 10 min)
Water inlet:
Flush-mount set:
WimTec power supply 230 V 50 Hz / 12 V=
Art.No. 117 899 - for one control unit
Art.No. 113 792 - for up to 5 control units
0,5 - 5 bar
10 bar
6 l/min (independent of pressure)
G 1/2" IT
W/H/D: 177 x 85 x 80 - 100 mm