Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
12. Servicing / Repair
12.1 Recalibration
It is possible that the offset value or the scaling value may shift during the lifetime of the
device. This is indicated by a deviation in the output signal value with reference to the set
measurement range start or end values respectively. If either of these two phenomena
should occur after a prolonged period of use, recalibration is recommended in order to en-
sure a continued high level of accuracy.
12.2 Return
Whenever the device is returned, no matter whether for recalibration, decalcification, modi-
fication or repair, it must be carefully cleaned and packed such that there is no risk of
breakage. The device must be accompanied by a notice of return giving a detailed descrip-
tion of the fault. If your device has come into contact with pollutants, then a notice of de-
contamination will also be needed. You can find the relevant templates on our website at
www.bdsensors.de. Should you send in your device without a notice of decontamination
and doubts with regard to the medium used should arise in our service department, repair
work will commence only once an appropriate notice has been received.
CAUTION
13. Disposal
The device must be disposed of in accordance with European Directives
2002/96/EC and 2003/108/EC (Waste Electrical and Electronic Equipment).
Waste electrical products may not be disposed of with household waste!
Depending on the medium used, residues on the device may constitute a hazard to the
operator and the environment. You must therefore take appropriate precautions if nec-
essary and dispose of the device properly.
14. Warranty Conditions
The warranty conditions are subject to the statutory warranty period of 24 months, starting
from the date of dispatch. No warranty claims will be accepted if the device has been used
improperly, modified or damaged. The warranty does not cover damaged diaphragms.
Warranty cover also excludes any claims for defects that have arisen as a result of normal
wear.
15. Declaration of conformity / CE
The supplied device fulfils the statutory requirements. The relevant directives, harmonized
standards and documents are listed in the EU Declaration of Conformity applicable to the
product. This can be found at http://www.bdsensors.de. In addition, the operational safety
of the device is confirmed by the CE mark on the type plate. See attachment 1.
Danger of injury from pollutants
If the device has come into contact
-
with pollutants, wear suitable protec-
tive clothing, e.g. gloves, goggles,
when cleaning it.
Werbung
Kapitel
Inhaltsverzeichnis
