Skoda 1ST 071 310E Montageanleitung Seite 25

THRESHOLD STRIPS - foil
The accessories are intended for professional fitting.
Škoda Auto recommends the fitting to be carried out by
its contract partners.
The threshold strip set 1ST 071 310E is designed for ve-
hicles Škoda Citigo in five-door version.
List of set parts (Fig. 1)
Threshold strips front (left - right) - position (A)
Threshold strips rear (left - right) - position (B)
Cleaning napkin (2 pieces) - position (C)
Spatula - position (D)
Attention. Each threshold strip has guide triangles.
Guide triangles serve for proper placement of the
threshold on the vehicle threshold in lateral direction.
Prior to gluing the threshold strips tear the foil off all
guide triangles.
Make sure you distinguish the threshold strips for the
left and right side of the car.
Note
Park clean vehicle (preferably washed in a car-wash) in
a dustfree area of a hall.
To ensure good quality of gluing the threshold strips it is
important that the ambient operating temperature was
within the range of 18 to 30°C. Ensure that the parts are
not exposed to direct sunlight.
Wash the door thresholds with a mild detergent solu-
tion and rinse with clean water. Then degrease them
using the attached cleaning napkin (C). Leave them for
10 minutes to breathe.
Important instructions for gluing threshold
strips
Threshold strips - front
- Place the threshold strip on the door threshold, accord-
ing to the dimension specified on Fig. 4. Using a suita-
ble marker, draw a point on the door threshold to place
the strip. Then place the threshold strip to the mark.
- Bend the longitudinal margin of the threshold strip
accordingly with the guide triangles. The guide tri-
angles on both sides of the threshold must precisely
copy the edge of the door threshold. Check the posi-
tion of the threshold strip. Then create guide marks
GB