HP Designjet 8000s Take-Up Reel Kit Installationshandbuch Seite 9

10. At the rear of the printer, insert the following connectors into the rear of the right take-up reel assembly
and secure them with the cable clip (3):
a. Insert the media sensor connector (1).
b. Insert the take-up reel motor cable connector (2).
11. Insert the connector on the other end of the motor cable (1) into the rear of the printer.
12. Secure the motor cable with the three cable clips (1) on the rear of the printer.
6 Installing the take-up reel ENWW