Weh TK26 CNG Betriebsanleitung Seite 9

- The WEH Product can become very hot or very cold due to the possible fluids
®
flowing through it, depending on the application and operating situation. In this
regard, observe the national and international regulations on occupational health
and safety to prevent injuries.
1�5 Definition of qualified personnel
- Qualified personnel, as defined by these instructions, are persons who, based on
their professional training, their knowledge (including the relevant standards and
regulations), experience and manual skills, can independently assess and properly
perform assigned work tasks (in conjunction with WEH
independently recognize and prevent potential dangers at an early stage.
2. INTENDED USE
- The WEH TK26 CNG Fueling nozzle has been developed exclusively for refueling
®
vehicles with compressed natural gas (CNG).
- The WEH Product is suitable for self-service operation.
®
Î Always ensure that the WEH
use. Please note in particular the technical data of the WEH
well as the marking on the WEH
Î When used at sea or near the sea, increased salt and moisture content of the air may
cause faster wear and corrosion of the product. Please observe the special mainte-
nance instructions in Chapter 9.2 Maintenance intervals on page 22.
- This WEH Product is generally classified as pressure accessory in accordance
®
with Article 2 (5) of the Pressure Equipment Directive 2014/68/EU and is con-
sidered to be similar to piping. This WEH
accessory. Furthermore, it is pointed out, that this WEH
and placed on the market in accordance with the requirements of Article 4 (3) of
the Pressure Equipment Directive 2014/68/EU. The assessment with regard to a
different classification can, however, be made on request.
Caution: Any use beyond the scope of application is considered as unintended use
and may result in personal injury and/or property damage.
Product is used only within the range of its intended
®
Product itself.
®
Product may not be used as safety
®
Operating instructions
Products) and can thus
®
Product in Chapter 4 as
®
Product is designed
®
MD-10501-L51-R2.1.0-03
AE
Page 9