Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
5. Maintenance
5.02 Everyday Maintenance
Clean : Keep all components of the electrical system clean. Clean gently with a damp, soft cloth. The components must not be immersed
into water or cleaned with a water jet or steam jet.
Tires
Pressure. Having the correct tire pressure gives more battery range due to fewer friction. The right tire pressure is between 3 and 4.
Tire wobble. A wobble in a tire indicates that the inner tube is not in its correct place. This can result in a flat tire. Deflate and adjust the
innertube. DIY or get help from your local bike shop.
Firmware : We recommend to download the Veloretti App when available. So you are able to update your Electric with the latest firmware.
5.03 Periodic Maintenance
With intensive use it is advised to check your bike more regularly. Also check your frame and fork for any signs of wear or damage.
Maitenance check : Taking care of your Veloretti is just like maintaining a regular bike. All professional bike shops can perform general
maintenance on our Electrics. We advise you to have the bike checked after riding the first 500 km, and after this every 1000 km or once a
year if you don't reach 1000 km.
Lubrication : Your bike is lubricated in the factory. Over time some moving components needs to be re-lubricated. We advise to check at
least the following components periodically if re-lubrication is necessary; Hubs, Pedals, Headset. Please do not use solvent based lubrica-
tion (i.e. WD-40) but use specialized bike-lubrication (i.e. ball bearing grease)
Hydraulic disc brakes : Check your disc brakes and brake pressure every 1000 km or at least once or twice a year.
Braking power. There needs to be space for at least 1cm between your brake lever and the handlebar. Not the case? Bleeding of the
brakes is required. Do it yourself, or get help from your local professional bike shop. You can use normal mineral braking oil if you need to
refill the brake fluid.
Squeaking braking sound? Your brake pads could be ready for replacement, or the brake disc needs cleaning. Do it yourself, or get help
from your local professional bike shop.
Saddle : Check your saddle bolt every month to see if the position changed or when your notice movement. Use the correct Nm to tighten.
See Chapter 6 for Newton chart.
Battery : When storing the battery if you are not using the bike for a long time you should charge the battery once in 3 months, this will
keep the battery "alive" and this will keep the battery capacity at his best.
Enviolo : We advise calibrating your Enviolo after every Enviolo firmware update, after a rear wheel repair/maintenance and once or twice
a year throughout the Veloretti App.
Tires : Tires should be replaced when the profile is gone or when the tire's rubber is drying, and you can see cracks in the rubber. When
you replace the tire you should replace the inner tube with it, they have the same lifespan. The size of tires you need is: 29x2.00/50-622.
Rims : Check for any loose or missing spokes. Loose, or too tight, spokes can also lead to a wobble in the rim or a crack in the rim.
Gates Carbon Belt Drive : Keep the belt clean with just some water. Check the tension of the belt. Move the belt up and down with your
fingers, the belt should be able to move approximately 0,5 cm up and 0,5 cm down. Inspect visual damage.
Check loose components : Make sure there are no loose parts on your bike. Tighten bolts accordingly (see Chapter 6 technical data for
Nw chart) when noticeable. Pay extra attention to the saddle, front wheel and rear wheel bolts.
Check damaged components : Check your electrical components for any damage and exposed live electrical components. When this is
the case, remove the battery immediately. If you have a question or problem, please contact Customer Care. A lack of expertise can lead
to severe accidents.
Firmware Update check : We recommend to download the Veloretti App when available. So you are able to update your Electric with the
latest firmware.
40
Werbung
