Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
4. Get to Know Your Bike
Charging the battery
See chapter 3.01 Battery charging for explained steps.
Charging
Use only the original battery charger supplied to you, as there is a risk of fire or explosion if the incorrect charger is used.
You can charge your battery when mounted on the bike or when it is removed.
Plug-in your charger first and then connect via the power socket.
Lithium-ion batteries are not subject to any memory effect. You can recharge your battery at any time, even after short journeys.
Charge the battery at temperatures between 0°C and 45°C (ideally at room temperature approx. 20 °C). Give your battery enough
time to reach this temperature before charging.
The charging time depends on several factors. It can vary greatly depending on the temperature, age, use and capacity of the
battery. When the battery is fully charged, the charging process stops automatically. Unplug the connector from the battery and
then removed from the mains.
LED charging state display
There is a light diode and button on the battery. The diode will light up if you push on this button. The diode will light up in various
colors. If the diode lights up in green the battery is fully charged. If the LED lights up red, you should charge the battery before your
next ride. The charge state of the battery will also be shown on the display.
Charging safety instructions
To prevent the risk of electric shock, you should never open the charger. Maintenance work may only be carried out by qualified
service personnel. Be sure to read the information about your charger before use! Unplug the power plug before connecting the
battery to the charger or removing it from the charger.
Keep the charger away from children and animals. In the event of malfunction or damage, it may result in a fire or electric shock.
• The charger must not be operated by children or people with limited sensory or mental disabilities.
• Do not use your charger if it is moist or dusty. Avoid direct sunlight.
• Disconnect the charger from the power supply when not in use.
• Use only the original charger that came with your Electric.
• Do not cover the charger while in use. There is the possibility of short circuits or fires.
• When cleaning the charger, unplug it from the power outlet first.
• Stop the Charge process if the charging cycle lasts longer than the length listed in the Specifications table.
32
Werbung
