Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
typical use. Do not overload
the wires by pressing down too
hard. Flying wire pieces can very eas-
ily penetrate thin clothing and/or your
skin.
• If a guard cover is recommen-
ded, do not allow the wire
brushes and the guard cover
to touch each other. The diameter
of plate and cup brushes can enlarge
if too much pressure and centrifugal
force is exerted.
Residual risks
There will always be residual risks even
if you operate this power tool according
to the instructions. The following hazards
may occur in connection with the type and
design of this power tool:
• Lung damage if suitable respiratory
protection is not worn.
• Hearing damage if suitable ear protec-
tion is not worn.
• Health injuries resulting from the effect
of vibration on the hands and arms in
the event that the device is used over
a longer period of time or is not used
and maintained properly.
• Damage to health as a result of:
• touching the area of the grinding
tool which is not covered;
• ejection of parts of workpieces or
damaged grinding discs.
WARNING! Danger due to electro-
magnetic field generated while the ma-
chine is in operation. Under certain cir-
cumstances, this field may negatively af-
fect active or passive medical implants.
In order to reduce the danger of serious
or fatal injuries, we recommend that indi-
viduals who wear medical implants should
consult their doctor and the manufacturer
of the implant before operating the ma-
chine.
38
Preparation
WARNING! Risk of injury due to un-
intentional start-up. Do not insert the plug
into the outlet until the device is fully pre-
pared for use.
Control elements
Familiarise yourself with the operating ele-
ments before using the device for the first
time.
• Speed regulator (3)
• The speed control (3) lets you
choose between six speed levels.
level 1 ⭢ lowest speed
level 6 ⭢ highest speed
• On/Off switch (5)
• Switching on: Press
• Lock: Tilt up in front
• Switching off: Release; if detected:
press briefly
• Spindle lock (12)
• Locks the spindle when attaching/
removing the attachment tool.
Attaching the auxiliary
handle
WARNING! Loss of control can result
in injuries! Only operate the machine with
the auxiliary handle attached.
Procedure
1. Screw the auxiliary handle (1) tightly
into one of the holders for the auxiliary
handle (2/8).
You can attach the auxiliary handle to
the right, left and top of the tool.
Attaching /adjusting/
removing the guard cover
Attaching and adjusting the guard
cover (Fig. B)
1. Pull out the device plug out of the
power outlet.
Werbung
