Funktionstaste
— Wenn durch Betätigen der Funktionstaste (Taste »
drücken) eine ausgewählte Funktion aktiviert werden soll.
Nacheinander » Einstellungen \ Instrument \ Funktionstaste «
auswählen und jeweils durch Drücken der Taste »
Gewünschte Funktion mit Taste »
ten Seite des Displays erscheint ein Symbol, entsprechend der
gewählten Funktion. Auswahl:
Spitzenwert
–
die größten Messwerte (bei O
ste) werden angezeigt
Halten
–
die vorliegenden Messwerte werden in
der Anzeige gehalten
Stiller Alarm –
der akustische Alarm ist deaktiviert.
Der akustische Alarm wird beim Aus-
schalten des Gerätes automatisch wieder
aktiviert. Die Belegung der Funktionsta-
ste bleibt aber erhalten.
Pumpe
–
die Pumpe ist ausgeschaltet
Lecksuche-
–
der Lecksuche-Modus mit dem CAT-Sen-
Modus CA
sor ist eingeschaltet (Voraussetzung:
CatEx-Sensor ist vorhanden und auf CH
konfiguriert)
Lecksuche-
–
der Lecksuche-Modus mit dem PID-Sen-
Modus PI
sor ist eingeschaltet (Voraussetzung: PID-
Sensor ist vorhanden)
CA–CH4
–
die schnelle Konfigurationsumschaltung
für den CatEx-Sensor ist aktiviert
IR–. . .
–
die schnelle Konfigurationsumschaltung
für den IR-. . .-Sensor ist aktiviert
All manuals and user guides at all-guides.com
« kurz
« aufrufen.
OK
« aktivieren – auf der rech-
OK
der klein-
2
4
Function key
— This function is used to define the function which is to be executed
when the function key is pressed (when the »
briefly).
Select the menu items » Settings \ Instrument \ Function key « in
this order, pressing the »
OK
Use the »
« key to activate the desired function. The
OK
corresponding icon then appears on the right side of the display.
The following functions are available for selection:
Peak value
–
The maximum measured values (the
minimum value for O
Hold
–
The currently displayed measured values
are held in the display.
Silent alarm
–
The audible alarm is deactivated.
The audible alarm is automatically
reactivated when the instrument is
switched off, but the function-key
assignment remains unchanged.
Pump
–
the pump is deactivated
Leakage-
–
the leakage mode with the CAT sensor is
Mode CA
switched on (prerequisite: CatEx sensor
is available and configured to CH
Leakage-
–
the leakage mode with the PID sensor is
Mode PI
switched on (prerequisite: PID sensor is
available)
CA–CH4
–
The quick-configuration changeover for
the CatEx sensor is activated.
IR–. . .
–
The quick-configuration changeover for
the IR-. . .-sensor is activated.
« key is pressed
« key after each selection.
) are displayed.
2
)
4
39