cecotec BOLERO DRESSCODE 7000 DN Bedienungsanleitung Seite 42

ENGLISH
Note
Do not put laundry in the washing machine during the drum cleaning.
Cleaning the door seals and glass
- Wipe the glass and seal after each wash to remove lint and stains. If lint builds up it can
cause leaks. Fig. 21
- Remove any coins, buttons and other objects from the seal after each wash.
Cleaning the inlet filter
Note
The inlet filter must be cleaned when there is little water.
Washing the tap filter. Fig. 22
1. Close the water supply tap.
2. Remove the water supply hose from the tap.
3. Clean the filter with a soft brush.
4. Loosen the water supply hose from the rear part of the washing machine. Remove the filter
with a pair of fine-tipped clippers, taking care not to damage it.
5. Use a soft brush to clean the filter.
6. Return the filter to its original position and connect the hose.
7. Clean the filter every 3 months to guarantee optimum functioning.
Cleaning the detergent dispenser tank. Fig. 23
1. Remove the detergent dispenser tank.
2. Press down the arrow on the softener cover inside the dispenser drawer.
3. Lift the clip up and take out the softener cover and wash all grooves with water.
4. Place the softener cover again and push it gently to introduce it in the detergent dispenser
in place.
Warning
Do not use alcohol, solvents or chemical products to clean the detergent dispenser.
Clean the tank about every 3 months.
Cleaning the drain pump filter. Fig. 24
Warning
- Be careful with the hot water!
- Allow any possible water remains to cool down.
- Unplug the machine to avoid electrical shock before washing.
- The drain pump filter can filter the yarns and small foreign matters from the washing.
- Clean the filter periodically to ensure proper operation of the washing machine.
82
BOLERO DRESSCODE 7000 DN
1. Open the lower cover cap.
2. Remove the filter by turning it counterclockwise.
3. Be careful, empty the water with a suitable container.
4. Remove dust, dirt and other substances or objects.
5. Place the filter again in its original position by turning it in the other sense.
6. Open the lower cover cap.
Warning
- Make sure that the filter is reinstalled correctly.
- Rotate the lower cover cap (filter) so water runs directly into a suitable container.
- When the appliance is in use and depending on the programme selected there can be hot
water in the pump. Do not remove the lower cover during the wash cycle, always wait until
the appliance has finished the cycle and is empty.
- When replacing the cover, ensure it is securely re-tightened.
6. TROUBLESHOOTING
Problem Cause
The door is not closed
The washing machine
properly. It is not connected
does not turn on
to a power outlet
The safety lock system is
The door does not open
activated
Bad connection between
Water leakage pipes and water supply hose
or drainpipe.
Detergent residues in the Detergent is dampened or
box agglomerated
ENGLISH
Solution
Restart after the door is
closed.
Check if there are clothes
stuck.
Plug it to a mains socket.
Check that the control and
protection elements of the
electrical installation are
activated.
Unplug it and restart the
product.
Check and fasten the water
pipes and hoses correctly.
Clean the hoses ensuring
they are not blocked.
Clean and wipe the detergent
box
83
BOLERO DRESSCODE 7000 DN