Werbung
Verfügbare Sprachen
Verfügbare Sprachen
• Check the covers and protective
devices for damage and correct fit. Re-
place these if necessary.
Change the cutter
Tools required
• Two-hole key (17)
• Phillips screwdriver (not included)
Procedure (Fig. C/D/F)
Switch off the tool and unplug the mains
plug. Allow the tool to cool down.
1. Loosen the screws (23) of the mainten-
ance cover (24) with a Phillips screw-
driver and remove the maintenance
cover (24).
2. Place the two-hole key (17) on the
clamping flange (25).
3. Press and hold the spindle lock (1).
Turn the two-hole key clockwise ⭮ .
After about half a turn, the spindle lock
engages and the clamping flange (25)
can be released ⭯ .
4. Remove the router blade (26) from
the mounting flange (27) and pull the
router blade (26) out of the base plate
(9).
Troubleshooting
The following table will assist you in fixing faults:
Problem
Device does not start
Engine is slowing down and
stops
5. Now insert the new router blade (26)
6. Reattach the maintenance cover (24)
Power cord
• Check the power cord for damage be-
• If the power cord of this device is dam-
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• protected against frost
• out of the reach of children
Possible cause
No mains power supply
On/Off switch (3) is broken contact the service centre.
Defective motor
Device is overloaded through
workpiece
NOTICE! Cutting injuries! Wear pro-
tective gloves whenever appropriate.
in reverse order.
NOTICE! Make sure that the direction
arrow on the tool (31) matches the dir-
ection arrow on the router blade (26).
with the screws (23).
fore each use.
aged, it must be replaced by the manu-
facturer or their representative to avoid
safety hazards. contact the service
centre.
Error correction
Check the socket, mains con-
nection cable, plug and fuse
and have them repaired by a
qualified electrician if neces-
sary.
contact the service centre.
Reduce pressure on attach-
ment tool
Workpiece unsuitable
GB
MT
31
Werbung
