Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
MT
Attaching the flat dowel cutter
Criteria
• Milling depth set and checked, see Set-
ting the milling depth, p. 28.
• Milling angle set, see Adjusting the
angle stop, p. 29.
• Height-adjustable stop set, see Adjust-
ing the height stop, p. 28.
• NOTICE! Use clamps or anoth-
er practical way to secure and
support the workpiece to a
stable platform. Holding the work-
piece by your hand or against the
body leaves it unstable and may lead
to loss of control.
Procedure (Fig. F)
1. Place the tool close to the workpiece.
2. The vertical centre mark (28) shows
the centre of the milling.
The maximum width of the milling is in-
dicated by the two cutter width marks
(29).
The horizontal centre marking (30) on
the base plate (9) helps to position the
height. The horizontal centre mark (30)
indicates the centre of the disc cutter.
Check the markings (28/29/30) and
make sure that the vertical centre mark-
ing (28) is aligned with the marking
line.
3. Now switch on the tool and push the
drive motor (7) forward against the
workpiece.
Connecting the workpieces
Criteria
• After a groove has been made on the
two workpieces, they can be joined.
Procedure (Fig. G)
1. Apply some glue in the grooves.
2. Insert flat dowels (32) into the corres-
ponding grooves.
3. Push both workpieces together.
30
4. Clamp the workpieces and wait until
the adhesive has hardened.
Transport
Information on transporting the tool:
• Switch off the device and disconnect
the plug from the power outlet. Make
sure that all moving parts have come to
a complete stop.
• Always carry the tool by the handle
(8).
Cleaning, maintenance
and storage
WARNING! Electric shock! Risk of in-
jury due to unintentional start-up. Protect
yourself when performing maintenance or
cleaning work. Switch off the device and
disconnect the mains plug from the socket.
You should have any repair and mainten-
ance work that is not described in these
instructions carried out by our Service
Centre. Only use original replacement
parts.
Cleaning
WARNING! Electric shock! Never
spray down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents
or solvents.
• Keep the ventilation slits, motor housing
and handles of the machine clean. Use
a damp cloth or brush to do this.
Maintenance
• Check the device before each use for
obvious defects such as loose, worn or
damaged parts.
Werbung
