Werbung
Verfügbare Sprachen
Verfügbare Sprachen
1
2
a a a
D0000072159
u Mark out holes 1 and 2 for drilling.
u Lift up the wall mounting bracket so that its lower slots
match up with the drill hole markings on the installation
wall.
u Mark out holes 3 and 4 for drilling.
u Drill the holes.
u Secure the wall mounting bracket with suitable fixing ma-
terials (screws, rawl plugs). Any drill hole discrepancies can
be compensated for with the slots.
5.3
Installing the appliance
D0000112448
1 Wall mounting bracket
u Hook the appliance onto the bottom tabs of the wall mount-
ing bracket by the slots in the back of the appliance.
u Place the appliance in an upright position.
u Push the appliance towards the supporting wall.
ð The appliance audibly snaps into place in the two upper
springs on the wall mounting bracket.
www.stiebel-eltron.com
Installation (qualified contractors)
3
4
1
D0000112449
1 Appliance
u Secure the appliance against unintentional release using
5.4
1
the supplied locking screw on the right or left-hand side of
the wall mounting bracket.
Electrical connection
WARNING
Electrocution
Incorrect electrical connection and installation work
may lead to serious injury through electrocution and
to appliance damage.
u Carry out all electrical connection and installation
work in accordance with national and regional
regulations.
u In the case of a permanent connection, ensure
that the appliance can be disconnected from the
power supply by an isolator with at least 3 mm
omnipolar contact separation.
u Please note that installing the appliance with a
fixed power cable is not permissible.
u Only an authorised electrician is allowed to make
the permanent connection to a junction box.
u Provide appropriate strain relief when making
the connection to a junction box.
u Ensure that the appliance is connected to the
earth conductor.
u Seal the trimmed cable ends again correctly with
wire ferrules.
NOTICE
Property damage
If the appliance is not operated at the correct mains
voltage, it will be damaged.
u Operate the appliance at the mains voltage stated
on the type plate.
u Ensure the on-site supply cable has an adequate
cross-section.
2
2 Locking screw
|
19
Werbung
