Herunterladen Diese Seite drucken

STIEBEL ELTRON CNS 500 Plus LCD Bedienung Und Installation Seite 16

Wandkonvektor

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Special information
1
Special information
– Keep children under the age of 3 away from
the appliance if constant supervision cannot
be guaranteed.
– Children from the age of 3 to 8 may switch
the appliance on and off, provided they are
supervised or have been instructed in the
safe operation of the appliance and under-
stand any risks that may result. This is sub-
ject to the appliance having been installed
as described. Children from the age of 3 to 8
must not plug the power cable into its
socket or regulate the appliance.
– This appliance may be used by people (in-
cluding children) with reduced physical,
sensory or mental capabilities or a lack of
experience and knowledge, provided that
they are supervised or have been instructed
on how to use the appliance safely by a per-
son responsible for their safety.
– Children must be supervised to ensure that
they do not play with the appliance.
– In closed rooms, temperatures can rapidly
reach high levels. Ensure constant supervi-
sion if the appliance is operated in a small
room and the persons within that room can-
not regulate the appliance or leave the
room on their own.
– Observe all applicable national and regional
regulations and instructions.
– Parts of the appliance can get very hot and
may cause burns. Particular caution is ad-
vised when children or vulnerable persons
are present.
– To prevent the appliance from overheating,
never cover it with anything.
– Never install the appliance directly below a
wall socket.
– In the case of a permanent connection, en-
sure the appliance can be separated from
the power supply by an isolator with at least
3 mm omnipolar contact separation.
– To prevent hazards, the power cable must
only be replaced (for example if damaged)
by a qualified contractor authorised by the
manufacturer, using an original spare part.
– Secure the appliance in place as described
in chapter Installation (qualified contractors)
[} 18] .
16
|
2
General information
Read these instructions carefully before using the
appliance and retain them for future reference.
Pass on these instructions along with the appliance
as necessary.
2.1
Symbols in this document
Symbol
Meaning
This symbol indicates possible property damage,
equipment damage, consequential damage or envir-
onmental damage.
General information is indicated by the adjacent
symbol.
This symbol indicates that you have to do something.
This symbol indicates that you must fulfil certain
prerequisites before you perform the following
steps.
This symbol indicates a result or intermediate result.
These symbols show you the software menu level (in

this example level 3).
This symbol indicates a reference to the correspond-
ing page number (page 11 in this example).
2.2
Symbols on the appliance
Symbol
Meaning
WARNING Overheating
u To prevent the appliance from overheating,
never cover it with anything.
u To prevent potential hazards, read these in-
structions carefully before use.
Do not dispose of the appliance as unsorted waste,
but take it to separate collection points for reuse and
recycling.
2.3
Units of measurement
All measurements are given in mm unless stated otherwise.
3
Safety
3.1
Structure of the warning notices
3.1.1 Section-specific warning notices
Section-specific warning notices apply to all steps in the section.
Injury
CAUTION
Type and source of risk
Consequence(s) of failure to observe the warning no-
tice
u Hazard prevention measure(s)
www.stiebel-eltron.com

Werbung

loading