Avtech AVH316 Bedienungsanleitung Seite 21

How to set a preset point:
Step1:
How to go to a preset point:
Step1:
4.5 Event Search
Note: This function is not available for "NORMAL" and "GUEST". For details, please refer to "4.3 User
Level Creation" at page 13.
In the playback control bar, click
QUICK SEARCH HARD DISK
RECORD
CHANNEL
MOTION
ALARM
TIME
SYSTEM
FULL
STATISTIC
00
EXIT
 To quickly search the time within which might include the recorded data you want to see:
- Select the channel(s) and month you want to search. You'll see the date(s) with recorded data is highlighted.
- Select the date you want to search. You'll see the time with recorded data is highlighted from the timeline bar.
- Click the time to start playback.
 To search the recorded data by event, select RECORD / MOTION / ALARM / TIME, or select FULL to show all the
event logs. Select the log you want to start playback.
Note: During video playback, you might click
the recorded audio (if any) on the channel you want.
All manuals and user guides at all-guides.com
Step2: Select the numbering within which saves the camera view you want to see,
and wait till you see
on the device status bar.
to enter the search list.
EVENT INFORMATION
2009
SUN MON TUE
1 2 3
8 9 10
15 16 17
22 23 24
29 30
06
15
Step2: Click or to the proper ratio you need, and click
/ / / to move to the point you want to
configure as a preset point.
Step3: Click the numbering you want to configure for this point,
and wait till you see
and disappearing on the device status bar.
Step4: Repeat from Step1 again to set other points if needed, or
click to return to the preset point selection panel
(command sending) appearing and disappearing
ALL HDD
2 SELECTED
NOV
WED THU
4 5
11 12
18 19
25 26
12 18
15 : 20
to check the recorded data details, or click
FREQUENTLY-USED FUNCTIONS
(command sending) appearing


FRI SAT
6 7
13 14
20 21
27 28
24
SUBMIT
to play