Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions TM 160/250/315 CNC
Message
Insert planer!
Reduce pipe
ends
distance!
Pipe Sliding!
Temp. low!
Temp. high!
Display page
PIPE
No signal from
PLANING.
the planer safety
microswitch; it's
not possible to
get the next
process step.
PIPE SLIDING
Not enough pipe
&ALIGNMENT.
material to grant
welding; it's not
possible to get
the next process
step.
PIPE SLIDING
Carriage position
&ALIGNMENT.
overtakes the
theoretical
contact point; it's
not possible to
get the next
process step.
INSERT
Measured
HEATING
temperature of
ELEMENT
heating plate is
lower than the
set welding
temperature; it's
not possible to
get the next
process step.
INSERT
Measured
HEATING
temperature of
ELEMENT
heating plate is
higher than the
set welding
temperature; it's
not possible to
get the next
process step.
Meaning
Possible causes
1) Planer is not
inserted in the
base
machine.
2) Planer is not
connected to
the hydraulic
unit.
Pipes length too
short at welding
side.
Pipe slipped in
the clamp.
1) Not enough
time passed
to complete
warming up
(less than 20
min).
2) Not enough
power to
heating
element.
Set temperature
has been
switched to a
lower value (e.g.
welding standard
changed).
15 Error/Warning messages
Actions
1) Insert the
planer.
2) Check
connection.
Quit the process
and adjust the
pipes position
before starting
again.
Quit the process,
adjust the pipes
position before
re-starting and
properly fix the
clamps!
1) Wait to
complete
warming-up.
2) Chek input
voltage from
generator or
mains.
Wait for cooling
down to set
temperature.
79
Werbung
