Marzocchi MONSTER-Serie Betriebs- Und Wartungsanleitung Seite 37

5.2 Compression adjustment
By acting on the adjustment screw (T), located
on bottom of the right leg, you can control the
fork's compression damping.
By turning the adjustment screw and using a
small, flat tip screwdriver, you can adjust the
hydraulic configuration of the inner valves that
control the compression.
• When turning the adjuster clockwise, you will
increase the compression damping, reducing
the travel that is achieved by the fork under
the same compression force.
• When turning the adjuster counterclockwise,
you will decrease the compression damping,
making the fork softer during impacts.
Do not force the adjuster screw (T) past its
limits.
5.3 Compression adjustment at
bottoming
By acting on the adjustment screw (C), located
on top of the left leg, you can control the fork's
compression damping and its resistance to
bottoming out.
By turning the adjustment screw and using a
small, flat tip screwdriver, you can adjust the
hydraulic configuration of the inner valves that
control the compression at the end of the travel.
By acting on this adjuster you can modify the
fork's behavior during the final part of its travel
only, without changing the fork's damping at the
beginning of its travel.
• When turning the adjuster clockwise, you will
increase the damping, helping prevent the
fork from bottoming out.
• When turning the adjuster counterclockwise,
you will decrease the damping.
Do not force the adjuster screw (C) past its
limits.
Adjustments
37
T
C