Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3.3
Wheel installing
Install the wheel in compliance with the bicycle
manufacturer's instructions.
For correct fork function, please follow the
instructions here below when installing the
wheel.
• In case the fork has been disassembled from
the bike frame or the fork's legs position in the
crowns has been changed, you will have to
slightly loose the 6 bolts (E) holding the arch
(D) by means of a 4 mm hex key.
• Insert the wheel axle (A) through the right
wheel axle clamp, then the wheel and the left
wheel axle clamp.
• By using a 6 mm hex key, tighten the axle bolt
(B) located on the left side to the required
torque (see Table 1 - Tightening Torques).
• Fully compress the fork a few times.
• By using the 5 mm hex key, tighten the bolts
(C) positioned on both dropouts to the
required torque (see Table 1 - Tightening
Torques), with the 1-2-1 sequence.
• By using the 4 mm hex key, tighten the bolts
(E) with the sequence 1-2-3-2-1 to the
required torque (see Table
Torques).
Incorrect wheel alignment can misalign the
legs make them unparallel, causing the fork to
bind.
C
1 - Tightening
5 mm
C
E
A
Installation
31
4 mm
D
E
6 mm
B
Werbung
