Werbung
Verfügbare Sprachen
Verfügbare Sprachen
4.2
Periodical maintenance table
General maintenance
operation
Clean stanchions and dust
seals
Oil change
Oil seals replacement
4.3
General safety regulations
After a complete breakdown, always use new seals when reassembling.
To tighten two bolts or nuts that are near each other, always follow the sequence 1-2-1 using the required
tightening torque (see Table 1 - Tightening Torques).
Never use flammable or corrosive solvents to clean the parts, as these could damage the seals. If
necessary, use specific detergents that are not corrosive, not flammable or have a high flash point,
compatible with the seals materials and preferably biodegradable.
If you are planning not to use your fork for a long time, always lubricate the forks stanchions and seals
with some fork oil before and after use.
Never pour lubricants, solvents or detergents which are not completely biodegradable in the
environment; these must be collected and kept in the relevant special containers, then disposed of
according to the regulations in force.
Use only metric tools, not standard tools, which may have similar sizes, but can damage the bolts and
make it impossible to unscrew them.
Use the right size and sort of screwdriver to unscrew slotted or crosshead screws.
When using a screwdriver to assemble or disassemble metal stop rings, o-rings, sliding bushings or seal
segments, avoid scratching or cutting the components with the screwdriver tip.
Only proceed to maintenance/overhaul operations if you are sure you are able to do it and you have the
right tools. If this is not the case, or if you are unsure, please contact an authorized service center, where
specialized technicians with the right tools and original spare parts will service and overhaul your fork,
putting it back into its original working conditions.
Only use original spare parts.
Work in a clean, ordered and well-lit place; if possible, avoid servicing outdoors.
Polished surfaces need to be periodically treated with polishing compound to be kept as new.
Carefully check there are no metal shavings or dust in the work area.
Do not modify the fork's components.
Use
Intense
After every ride
50 hours
50 hours
Maintenance
33
Normal
100 hours
100 hours
Werbung
