Werbung
ENGLISH
If the power the cord is damaged,
•
it shall be replaced by authorized
service only to avoid any risk that
may occur.
Do not tuck the power cord under
•
the product or to the rear of the
product. Do not put heavy items
on the power cord. The power cord
should not be bent, crushed, or
come into contact with any heat
source.
Do not use an extension cord,
•
multi-plug or adaptor to operate
your product.
Portable multi sockets or portable
•
power supplies may overheat and
cause fire. Thus, do not have a
multi-plug behind or in the vicinity
of the product.
The plug shall be easily accessible.
•
If this is not possible, a mechanism
that meets the electrical legislation
and that disconnects all terminals
from the mains (fuse, switch, main
switch, etc.) shall be available on
the electrical installation.
Do not touch the plug with wet
•
hands.
When unplugging the appliance,
•
do not hold the power cord, but
the plug.
HANDLING SAFETY
This product is heavy, do not
•
handle it by yourself.
Do not move the product by
•
holding the door.
Be careful not to damage the
•
cooling system and the pipes
while handling the product. Do not
operate the product if the pipes
are damaged, and contact an
authorized service.
INSTALLATION SAFETY
To prepare the product for
•
installation, see the information in
the user guide and make sure the
electric and water utilities are as
required. If the installation is not
suitable, call a qualified electrician
and plumber to have them make
the necessary arrangements.
Otherwise, electric shock, fire,
issues with the product or injuries
may occur.
Check for any damage on the
•
product before installing it. Do not
have the product installed if it is
damaged.
Place the product on a level and
•
hard surface and balance with the
adjustable legs. Otherwise, the
refrigerator may tip over and cause
injuries.
The product shall be installed in a
•
dry and ventilated environment.
Do not keep carpets, rugs or
similar floor covers under the
product unless recommended by
the supplier. This may cause risk
of fire as a result of inadequate
ventilation!
Do not block or cover ventilation
•
holes. Otherwise, power
consumption may be increased
and damage to your product may
occur.
Do not connect the product to
•
supply systems such as solar power
supplies. Otherwise, damage to
your product may occur as a result
of the abrupt voltage fluctuations!
The more refrigerant a refrigerator
•
contains, the bigger its installation
room shall be. In very small rooms,
a flammable gas-air mixture may
occur in case of a gas leak in the
cooling system. At least 1 m³ of
volume is required for each 8
grams of refrigerant. The amount
of the refrigerant available in your
product is specified in the Type
Label.
The installation place of the
•
product shall not be exposed to
direct sunlight and it shall not be in
the vicinity of a heat source such as
stoves, radiators, etc.
If you cannot prevent installation
A
of the product in the vicinity of a
heat source, you shall use a suitable
insulation plate and the minimum
distance to the heat source shall be as
specified below.
- At least 30 cm away from heat
sources such as stoves, heating units
and heaters, etc.,
5
Werbung
