Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Wall mounting
•
For wall mounting, drill two 10 mm diameter holes (538/675/696 mm) with the
vent hole on the top of the cooker hood in the middle as shown below. Make
sure the hood is right over the hob.
•
Insert two plastic dowels (provided) into the holes.
•
Insert two screws into the top two plastic dowels and tighten them until they
protrude 3 mm from the wall.
•
Place the extractor hood on the two screws and mark the two bottom screw
positions.
•
Remove the hood, drill the two bottom screw holes and insert the plastic
dowels.
•
Place the hood on the top screws, insert the bottom screws and tighten all
screws completely.
Contempo 60
Contempo 90
4 ST5*49
EN
33
Werbung
