Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Information
•
For proper combustion and the extraction of gases through the exhaust
pipe (chimney) of combustion systems, sufficient air is required to prevent
backflow. With fans without ducts, ventilation must always be vented outside.
•
When assessing air pressure, the entire ventilation system of the house/
apartment must be taken into account, e.g. hob and/or gas stove - this rule
does not apply here.
•
The legal regulations must be observed when conducting exhaust air. If the
extractor hood is used in recirculation mode with an activated carbon filter,
there are no restrictions on operation.
•
If you choose exhaust mode, you should insert a check valve into the vent hole
Preparation for assembly
Make sure the power is turned off before
starting assembly. The plug must be
positioned so that it can be easily inserted
and removed.
Two helpers are required to assemble this
hood. For complete assembly you will need
the following tools and materials.
Required tools
•
Drill suitable for your wall
•
Phillips screwdriver
•
Tape measure
•
Hand saw or jigsaw
A
597/897mm
Min. 650mm
Max. 750mm
EN
31
Werbung
