Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
32
The assembly work and electrical installation must be carried out by qualified
persons in accordance with all applicable regulations and standards, including fire
protection.
•
Do not direct exhaust air into the flue of other appliances that burn gas or
other fuels.
•
Regulations for the discharge of exhaust air must be observed.
•
The extractor hood must be installed at a minimum distance of 65 cm above
the hob of the stove.
•
The extractor hood may be installed at a maximum distance of 75 cm above
the hob of the stove.
Mounting on a cabinet
•
Drill one 130 mm diameter hole and four 3.5 mm diameter holes as shown
below.
•
Warning: Failure to install the screws or fastener in accordance with these
instructions may result in an electrical hazard.
•
ATTENTION: If your extractor hood is running in recirculation mode, it is not
necessary to drill a 130 mm diameter hole.
•
Use the 4 screws to attach the extractor hood to a kitchen cabinet and check
the correct fit of the attachment by test fitting the extractor hood. When
everything is in place, fix the unit in position. Tighten the screws if necessary.
Tighten the screws if necessary.
Contempo 60
Contempo 90
4 ST5*49
Werbung
