ROBBE Power Peak Quad EQ-BID 230 V Bedienungsanleitung Seite 42

Power Peak® Quad EQ-BID 230 V
The double beep indicates that the change has been stored successfully. Answer the
safety query with 'NO' if you do not wish the changed data to be adopted. In both cases,
the programming display is shown again.
8.3 REaDING ThE DaTa STORED ON ThE BID chIP / BID KEy
If you have a battery with a BID chip and once connected to the charger, the following
battery data can be read out to give you an accurate display of the battery state.
tions is displayed.
9. chaRGE / DISchaRGE PROcESSES WITh a BID chIP / KEy
BID chip / keys are so small that you can slip them into whatever other accessories you
are using. The pictures on the next page show how BID chips are used.
Operating Instructions
When you have finished entering the parameters,
you must conclude the procedure by pressing the
'ENTER' button once more; this stores the new valu-
es permanently in the BID chip. a security query
will appear if data is changed during entry. To
save the data, you must change the answer to
'yES' with the 'INc' or 'DEc' button and then
finally confirm by pressing ENTER.
Data is stored on the BID chip / BID key, and can
be read.
Pressing the '+' button twice displays the first para-
meter on the screen. This is the capacity of the
charge or discharge process in progress.
Pressing the 'INC' button twice more displays the
second parameter on the screen. The maximum
capacity value of all charging or discharging opera-
Pressing the 'INC' button twice more displays the
final parameter: this is the number of charge cycles
and the programmed date.
18
Order No.
8196