ROBBE Power Peak Quad EQ-BID 230 V Bedienungsanleitung Seite 31

Power Peak® Quad EQ-BID 230 V
STOP / ENTER BUTTON
• A current operation, e.g. CHARGE, can be terminated by pressing the STOP button.
• The ENTER button confirms a selection, e.g. activation or deactivation of a selected
menu.
DaTa VIEW BUTTON
• Shows the charger data, e.g. input voltage. Pressing this button also shows all indivi-
dual cell voltages of a connected LiPo battery pack.
all buttons have an autorepeat function so that the respective function is repea-
tedly switched when the button is held pressed.
INTEGRaTED SOUND GENERaTOR
• The piezo buzzer confirms each time a button is pressed and acoustically signals the end
of charging/discharging as well as any faults.
4. TEchNIcaL SPEcIfIcaTION
Operating Voltage:
Cell count:
Charging current:
Discharging current:
Equalizing current:
Charging power:
Discharging power:
Trickle charge:
Cut-off voltage:
Charge Cut-Off:
NC/NiMH:
Lead and lithium:
Dimensions:
Functions:
Note:stated values refer to a single charge output port!
Operating Instructions
230 V AC/ 50 Hz
1 ... 14 cells NC/NiMH,
1 ... 6 cells LiIo (3.6 V), LiPo (3.7 V), LiFe (3.3 V)
1 ... 6 cells (2...12 V) lead-acid battery
0.1 ... 5 A at max. 50 W
0.1 ... 1 A at max. 5 W
max. 250 mA
50 W, current is controlled to suit
e.g. 24 V battery voltage, charging current approx. 2.0 A
e.g. 28 V battery voltage, charging current approx. 1.7 A
5 W, current is controlled to suit
Charged capacity <1 Ah: No trickle charge
Charged capacity >1 Ah: Trickle charge at C/20
(only with NC and NiMH)
0.8 V per cell for NC and NiMH,
3.0 V per cell for LiPo, Lilo
2.5 V per cell for LiFe
1.8 V per cell for lead batteries
automatic, digital Delta-Peak system
automatic, voltage-dependent, CC-CV method
est. 225 x 170 x 40 mm
Charge, discharge, discharge-charge, balance
10 internal memory locations
7
Order No.
8196