Stihl KGA 770.0 Gebrauchsanleitung Seite 29

13 After Finishing Work
► If the reset button (1) does not engage in posi‐
tion: Wait a few minutes and then depress the
reset button (1) again.
The push sweeper has not cooled down suffi‐
ciently.
► Insert the battery and switch the push sweeper
on.
13 After Finishing Work
13.1 After Finishing Work
► Switch off the push sweeper and remove the
battery.
► Remove the container and empty it.
► If the push sweeper is wet: allow the push
sweeper to dry.
► If the battery is moist or wet: allow the battery
to dry, 20.4.
► Clean the push sweeper.
► Clean the circular brush and sweeper drum
assembly.
► Clean the battery.
14 Transporting
14.1 Transporting the Push
Sweeper
► Switch off the push sweeper and remove the
battery.
Moving the push sweeper
► Move the push sweeper slowly and steadily
forwards.
Carrying the push sweeper
1
► Fold the push handle (1) down.
► Grip the push sweeper by the handle (2) and
set it up vertically.
0458-769-9801-A
2
► Carry the push sweeper by the handle – the
circular brushes must face away from the
body.
Transporting the push sweeper by vehicle
► When you wish the push sweeper to be trans‐
ported in a space-saving manner.
► Dismantle the push handle with the holder.
► Position the push sweeper so that the bristles
of the circular brushes are not bent.
► Secure the push sweeper with a lashing strap
between the container and the housing.
► Secure the push sweeper so that it cannot tip
over or move.
Dismantling the push handle with the holder
1
2
2
► Position the push handle (1) at an angle of
45°.
The arrows (4) on the housing must align with
the crosspiece (3) on the holder (2).
► Pull the holder (2) somewhat apart and
remove it.
English
3
4
29